Trad Talk Forums banner

Sky Hawk limbs and a Rambo Jr riser

2K views 5 replies 3 participants last post by  BigHink66 
#1 ·
Can these 2 work together?
 
#2 ·
Sorry Hink, hopefully someone will know.
I read that the Sky Hawk - the Earl version - is a 3 piece takedown, and limbs use pins to locate.
are you referring to the Earl Hoyt version of limbs?
I'm well familiar with Rambo risers, but not the Rambo Jr.
Does JR. use the same limb pockets & fastening system as the Rambo?
 
#5 ·
I think you can even take ILF limbs and alter them to fit, by lengthening the slot, and if I recall it right, you will need to cut off the butt-end a tad, so the distance from limb bolt to the little circle in riser where fitting sits matches up well.....get measurements well first......don't go too far too fast......with either length of slot or length of entire limb butt.
And take out the ILF fittings and use DAS fittings....that is a perfect fit.
I thought of doing this several times, but I did not have a lower line of ILF limbs I felt like altering.
I had the limbs side-by-side - - a good set of Hunter Supreme limbs that worked well, and compared to ILF ones, and it looks do-able.
I have a set of SUPREME limbs on a Rambo- Hunter Supreme, I can get you any measurements you need to make it work, if you try it.
OR you can use Loc Do's plates on your riser, and go ILF......
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top